Hello everyone! This is my first 3D print. The object pictured above is actually the third time I tried printing the dodecahedron. The first two prints were a bit warped, so I had to do some troubleshooting. After leveling the bed multiple times, I realized that the belt on the X-axis (I believe) was loose, so I had to tighten it. Once I did that, it resolved all of my issues, and I ended up with a nice print.
As for setting up the printer initially, the manual and video were hard to follow at times, as I felt they skipped over some important details. I had to figure out a lot of the setup on my own.